Why Are High-Chromium Cast Iron Liners Used for Raymond Grinding Mills?
- Time:2026-11-16
- Views:0
As core wear parts, liner plates of Raymond grinding mills directly affect mill operation stability. Thanks to high hardness, excellent wear resistance and low full-life-cycle cost, high-chromium cast iron has become the mainstream material for Raymond mill liners.
Liner plates for Raymond grinding mills in the industry are generally made of high-chromium cast iron (Cr15~Cr26), instead of ordinary steel plates or high manganese steel, mainly based on the following two considerations.
Wear Resistance of Cast Iron Liners Matches the Wear Conditions of Raymond Grinding Mills
Fixed on the inner side of the mill housing, liners are mainly subjected to two types of wear. The first is high-stress abrasive wear, which refers to cutting caused by hard particles pressing into the liner surface when materials are crushed between grinding rollers and rings. The second is erosion wear, where fine powder carried by airflow sweeps across the liner surface at high speed, especially near the air duct. Under dual wear conditions, the primary performance requirement is excellent wear resistance to protect the mill housing.
Ordinary steel plates only have a hardness of HRC 20~30, and obvious grooves will form within several weeks if used as liners. High-chromium cast iron reaches HRC 58~65. The dispersed M7C3 carbides (HV 1800~2200) in its matrix form a microscopic wear-resistant skeleton. It maintains high hardness without impact, and its wear resistance is about 5~8 times that of ordinary steel plates.
By contrast, high manganese steel relies on work hardening under strong impact (impact energy is required to raise its surface hardness from HB200 to above HB500). During Raymond mill operation, the impact force on liners is small, so high manganese steel cannot be fully hardened, resulting in poorer wear resistance than ordinary carbon steel.
Cast Iron Liners for Raymond Grinding Mills Deliver High Cost Performance
Although the unit procurement cost of cast iron liners is slightly higher than ordinary steel plates, their overall cost over the full life cycle is much lower. Ordinary steel liners usually need replacement after 1~2 months of continuous operation, while high-chromium cast iron liners can serve 6~12 months with fewer maintenance shutdowns, supporting continuous production of Raymond mills. It should be noted that high-chromium cast iron has low toughness. If hard foreign objects such as iron blocks or bolts enter the material, brittle fracture may occur. Therefore, magnetic separators are normally equipped on production lines to remove iron impurities.
| High-Chromium Cast Iron | Ordinary Steel Plate | High Manganese Steel |
| HRC 58~65 | HRC 20~30 | HRC 20, 40~55 after impact |
| Service life: 6~12 months | Service life: 1~2 months | Service life: 2~4 months |
| Low frequency of shutdown maintenance | High frequency of shutdown maintenance | Medium frequency of shutdown maintenance |
| Slightly higher unit procurement cost | Low unit procurement cost | Medium unit procurement cost |
| Lowest full-life-cycle cost | High full-life-cycle cost | Relatively high full-life-cycle cost |
- Previous Article:Not Available
- Next Article:What is an Ultrafine Grinding Mill?










Home
Products
About
Call